Home · Services · Garage Door Opener Repair
Troubleshooting and repair of a garage door opener that will not run, runs and reverses, or has lost its remotes, keypad, or safety sensors.
Opener repair follows the cold: a door reversing in January is often ice at the threshold, a stiff door, or frost-shifted sensors rather than a dead opener. The diagnosis separates the door's mechanical state from the opener's electronics before any unit is sold, because a new opener over a binding door inherits the binding and the argument.
An opener failure is an emergency only when it strands a car or leaves the door open. Otherwise it is a this week repair. If the door itself is heavy or crooked, the opener is the messenger, not the problem, and repairing the messenger alone wastes the visit.
PLACEHOLDER
Diagnosis and repair of a garage door that will not open, will not close, opens partway, or runs rough and loud.
Replacement of a broken torsion or extension spring, the part that actually lifts the door, matched to the door's weight and cycle rating.
Replacement and installation of a new garage door opener, sized to the door, with modern safety sensors, remotes, and battery backup options.
Replacement of one or more damaged garage door sections, matched to the door's model and profile where the manufacturer still supports it.
An opener failure is an emergency only when it strands a car or leaves the door open. Otherwise it is a this week repair. If the door itself is heavy or crooked, the opener is the messenger, not the problem, and repairing the messenger alone wastes the visit.
The main price factors for garage door opener repair are covered in the cost section above. The contractor confirms the exact price in a written estimate after seeing the job, and nothing is owed until you approve it. The call and the referral are free.
This is the one garage job the trade itself tells homeowners to skip. A wound torsion spring holds enough stored energy to drive a winding bar through a hand or a face, and spring injuries are a steady emergency room category every year. The parts are cheap and the labor is the knowledge of how not to get hurt. Cables under spring tension carry the same warning. Rollers, hinges, weather seal, and sensor alignment are reasonable DIY; springs and cables are the line.
A working rule: a visual once over twice a year, and a professional tune up when the door gets loud, slow, or uneven. Check monthly that the auto reverse works (the door should reverse when it meets a roll of paper towels on the floor) and that the sensors reverse it when the beam breaks. In cold climates, do the twice yearly check in fall before the cold sets springs up to fail, and in spring after the salt season has had its way with the bottom panel and cables.
No, and in a Bloomington January that answer is practical, not cautious. The springs do the lifting; the opener only guides a balanced door. Running an opener against an unsprung door can burn out the motor and bend the top panel, converting a spring job into a spring and opener job. Use the manual release once, with help, only if you must move the door, and treat it as the dead weight it is. The repair replaces springs in a matched pair weighed to your door, with cables read in the same visit.
Prefer to talk later? Leave your details and an independent local pro will call you back. No charge to you, no obligation.
Kirkwood Garage Door Co is a free referral service. Submitting this form connects you with independent local contractors who provide the work.